- When lighting the stove for the first time only a small fire should be lit.
- Too hot a fire will result in the paint emitting smoke – not necessarily bad but unpleasant.
- The paint may also become soft at this time. Avoid all contact as the finish is easily damaged!
- the rope seal of the door may also stick to the body of the stove – leave the door slightly open on first use!!
- The heatproof paint hardens after a couple of hours with a hot fire.
- If it hasn’t, the fire isn’t hot enough.
- It is recommended that doors or windows be opened the first time the stove is fired.
- Vibration caused by transport may loosen nuts/bolts securing glass, door handles etc., so please check these and tighten before use. Do not overtighten brackets securing the glass, & make sure glass seals are correctly positioned.
- Some models have a spring-loaded door. This can be slackened off or removed entirely. It is a safety feature for some European countries so that they can use two stoves in the same flue, which you cannot in the UK.
- Before lighting check that the removable baffle, which you will find inside the combustion chamber at the top, is pushed towards the back of the stove. Sometimes this gap is too narrow because the baffle has moved out of place, or on one occasion, the fitter had put it back upside down… There is sometimes a small piece of wood holding these in place, visible from the flue exit. It can be left in situ and will burn off during first use.
- Check also that other internal components are in position. Remove all supplementary tools from the ash pan, as well as warming oven stones/bricks.
- Primary air passes through the the grate and through the fuel. It is useful for igniting the fire and for burning solid fuels such as coal.
- Wood burns most efficiently when the air is supplied from above rather than below; so use the secondary air most of the time.
- It is a common complaint of DEFRA and Ecodesign stoves that they don’t respond as quickly to adjustment of the controls, which is true, but they do respond more albeit more slowly.
Lighting the stove – see Burning Wood > lighting a fire.
TROUBLESHOOTING
Blackened glass
• The wood is too damp. Only use wood stored for at least 12 months under cover and with a moisture level not exceeding 18% RH.
• Insufficient intake of air from the top air control. Open the top air control further. The air shield system is more efficient the more air is allowed to run over the glass panel.
• The stove is run at too low a temperature.
Smoke in the room when opening door
• Never open the door when there are high flames on the wood.
• Poor chimney performance – consult chimney sweep.
•Check the position of any fitted flue damper or stabiliser and make sure it is in the open position.
Uncontrollable combustion
- Worn door seal. Fit new seal.
- excessive chimney draft – fit a draft stabiliser in the flue pipe – consult a chimney sweep.
Excessive smoke and no draught when igniting the fire
• Flue pipes and/or chimney not sealed
• Flue of insufficient length
Room cannot be heated effectively
• Poor Insulation
• Poor quality fuel
• Ash blocking the grate
• Insufficient air provided
Stove radiates too much heat
• Too much air provided
• Excessive draw from the chimney (fit a draught regulator)
Grate damaged or slag formed
• Stove is repeatedly overloaded
• Inappropriate fuel is being used
• Too much primary air provided
• Excessive chimney draw